Magnetek Flex 12RS System Información técnica descargar pdf (Pagina 9)

Flex M Engineered Receiver Instruction Manual

October 2014

Page 9 of 49

 Operate any material handling equipment using a damaged controller because the unit may be

unsafe

 Operate manual motions with other than manual power

 Operate radio controlled equipment when low battery indicator is on

WARNING

THE OPERATOR SHOULD NOT ATTEMPT TO REPAIR ANY RADIO CONTROLLER. IF ANY PRODUCT

PERFORMANCE OR SAFETY CONCERNS ARE OBSERVED, THE EQUIPMENT SHOULD IMMEDIATELY

BE TAKEN OUT OF SERVICE AND BE REPORTED TO THE SUPERVISOR. DAMAGED AND INOPERABLE

RADIO CONTROLLER EQUIPMENT SHOULD BE RETURNED TO MAGNETEK FOR EVALUATION AND

REPAIR. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH AND

DAMAGE TO EQUIPMENT.

2.4 PRE-OPERATION TEST

At the start of each work shift, or when a new operator takes control of the crane, operators should do, as

a minimum, the following steps before making lifts with any crane or hoist:

 Test all warning devices.

 Test all direction and speed controls.

 Test the receiver emergency stop.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 48 49

Sin comentarios

Magnetek Flex 12RS System Información técnica Pagina 9