Magnetek Flex 12EX System Manual de usuario descargar pdf (Pagina 19)

Page 18

OFF

3rd

SPEED

d. START/AUX Function

After initiating the START function the Start position will become an auxiliary function with

momentary contact. For auxiliary application such as horn or buzzer, please connect it to the

FUNC output relay (wire #6) located inside the receiver unit.

e. Magnet ON/OFF Push Button Function

The user can set any of the two adjacent push buttons on the transmitter to control a magnet. To

activate the magnet just press the push button with the Magnet symbol. To deactivate the magnet,

for safety purpose, you must first press and hold the Magnet push button and then press the OFF

push button. Press the OFF push button by itself can not deactivate the magnet (refer to page 20

on how to set to this function).

f. Brake Function

When the transmitter push button is released from 2

speed up to 1

speed, both 1

and 2

speed output relays will open for up to 1.0 second and then with 1

speed output relay closed

thereafter (refer to page 20 on how to set to this function).

g. Momentary Contact

When push button is released the output relay corresponds to that push button will open (refer to

page 21 on how to set to this function). This type of contact is usually applies to external

application such as horns or buzzers.

h. Toggled Contact

When push button is released the output relay corresponds to that push button will remained

closed (maintained contact) until next time the user presses the same push button again (refer to

page 21 on how to set to this function). This type of contact is usually applies to external

application such as lights.

i. 3

Speed Push Button Function

This function allows the crane to travel an additional step beyond 2

speed. For example, if the

operator is pressing the “UP” push button down to 2

speed, pressing the 3

speed push button

(with “UP” push button still hold at 2

speed) will toggle between 2

speed and 3

speed (refer

to page 21 on how to set to this function).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 36 37

Comentarios a estos manuales

Sin comentarios

Magnetek Flex 12EX System Manual de usuario Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control Magnetek Flex 12EX System