Magnetek Flex 12EX System Manual de usuario descargar pdf (Pagina 20)

Page 19

Aux

STOP

41 32 65 87

4132 65 87

4231 7856

41 2 3 65 78

j. Auxiliary STOP Push Button Function

The auxiliary STOP function acts as a 2

emergency stop button. Other than by emergency stop

button and transmitter power key switch, the receiver MAIN is also deactivated when this

auxiliary stop push button is pressed (refer to page 21 on how to set to this function).

k. Pitch & Catch Function

This function allows two operators controlling one crane from opposite ends of a cross or long

travel (refer to page 21 on how to set to this function). When set to “Pitch & Catch” make sure

the 2

transmitter is set to the next upper channel (channel X*+1). For example, if the system is

preset at “Ch.01” then the channel of the 2

transmitter should be set to “Ch.02”. Furthermore,

the dip-switch position #7 and #8 on the receiving module should be set to “01”, this will allow

the receiver to scan only Ch.01 and Ch.02 (please refer to the illustration below). On the other

hand, since there are only 62 available channels on the Flex system, the system preset at channel

62 is ineffective because the 2

transmitter can not be set to Ch.63. If your system is preset at

Ch.62 do make sure to change it to another channel.

3. Receiver Auto-Scanning Settings

Receiver Channel Dip-switch

↓

(1) → Scanning all 62 channels (manufacture preset)

For standard operation

(2) → Single fixed channel (channel X*)

Auto scanning function disabled

(3) → Scanning 2 channels only (channel X*, channel X*+1)

For Pitch & Catch, Tandem, and Random Access operation with 2 receivers

(4) → Scanning 3 channels only (channel X*, channel X*+1, channel X*+2)

For Random Access operation with 3 receivers

* Channel X → Channel set on the receiving module

Example: If the first 6 dip-switch positions on the receiving module is set to Ch.01 (“000000” or

“000001”), when set to 2-channel scanning (type-2 above), then the receiver will only

scan Ch.01 and Ch.02.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 36 37

Sin comentarios

Magnetek Flex 12EX System Manual de usuario Pagina 20