Magnetek Flex 12EX System Manual de instrucciones descargar pdf (Pagina 28)

Flex 12EX System Instruction Manual

December 2013

Page 28 of 48

4.1.5 I-CHIP

The I-CHIP functions in a way that is very similar to a SIM card inside a mobile phone, which

stores system information such as your telephone number, account number, phone book and

other settings. The I-CHIP works exactly the same way, as it stores information such as system

serial number/ID code, channel and push button configurations.

When replacing a transmitter handset, just take the I-CHIP out of the old transmitter and install it

into the new one (refer to Fig. 11 below). For a complete information transfer, make sure both the

Channel and Function dip-switch is set to all “1”. If both dip-switches are set to all “1”, then the

transmitter will operate according to the push button configurations and channel stored inside the

I-CHIP. If both the Channel and Function dip-switch is set to other values other than all “1”, then

the transmitter will operate according to the channel and push button configurations set on these

two dip-switches, not the ones stored inside the I-CHIP. Every time the settings on these two dip-

switches are changed, the new settings will be stored into the I-CHIP automatically. In this case

the previous channel and push button configurations stored inside the I-CHIP will be erased and

be replaced by the new settings.

For safety purposes, the system serial number/ID code stored inside the I-CHIP cannot be

changed directly on the transmitter encoder board. Only channels and push button

configurations can be changed directly on the encoder board via Channel and Function dip-

switches. There are only two ways that you can change a transmitter serial number/ID code: via

the I-CHIP programming port located on the decoder module inside the receiver unit, please

refer to page 37 on how to program the I-CHIP (serial number/ID code) via receiver unit; or via

an external I-CHIP programmer or duplicator unit available from the factory. Please ask your

local dealers for assistance if your system requires serial number/ID code adjustments.

(Fig. 11)

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Sin comentarios

Magnetek Flex 12EX System Manual de instrucciones Pagina 28