Magnetek Flex 12EX System Manual de instrucciones descargar pdf (Pagina 32)

Flex 12EX System Instruction Manual

December 2013

Page 32 of 48

OFF

3rd

SPEED

4.2.2.4 START/AUX Function

After initiating the START function the Start position will become an auxiliary function with

momentary contact. For auxiliary applications such as a horn or a buzzer, please connect it to

the FUNC output relay (wire #6) located inside the receiver unit.

4.2.2.5 Magnet ON/OFF Push Button Function

The user can set any of the two adjacent push buttons on the transmitter to control a

magnet. To activate the magnet just press the push button with the Magnet symbol. To

deactivate the magnet, for safety purpose, you must first press and hold the Magnet push

button and then press the OFF push button. Pressing the OFF push button by itself cannot

deactivate the magnet (refer to page 34 on how to set to this function).

4.2.2.6 Brake Function

When the transmitter push button is released from 2

speed up to 1

speed, both 1

and 2

speed output relays will open for up to 1.0 second and then with 1

speed output relay closed

thereafter (refer to page 34 on how to set to this function).

4.2.2.7 Momentary Contact

When push button is released the output relay corresponds to that push button will open

(refer to page 34 on how to set to this function). This type of contact is usually applies to

external application such as horns or buzzers.

4.2.2.8 Toggled Contact

When the push button is released the output relay corresponds to that push button will

remain closed (maintained contact) until the next time the user presses the same push

button again (refer to page 35 on how to set to this function). This type of contact is usually

applied to external application such as lights.

4.2.2.9 3

Speed Push Button Function

This function allows the crane to travel an additional step beyond 2

speed. For example, if

the operator is pressing the “UP” push button down to 2

speed, pressing the 3

speed push

button (with “UP” push button still hold at 2

speed) will toggle between the 2

speed and 3

speed (refer to page 35 on how to set to this function).

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 47 48

Comentarios a estos manuales

Sin comentarios

Magnetek Flex 12EX System Manual de instrucciones Pagina 32

Comentarios a estos manuales