Magnetek Flex 12EX System Manual de instrucciones descargar pdf (Pagina 29)

Flex 12EX System Instruction Manual

December 2013

Page 29 of 48

71 423 56 8

INTEXT

12356847

4.2 RECEIVER UNIT

4.2.1 System Channel Settings

(Fig. 12)

Even though the Flex system is equipped with an automatic channel scanning receiver, the user

can also set the receiver channel manually. Please refer to page 33 on how the automatic

channel scanning receiver works.

Set the receiver channel by adjusting the channel dip-switch located on the receiver module

(refer to Fig. 12 above), only the first six (6) positions are used for channel programming (refer to

Fig. 13 below). The system channels table located on page 38 illustrates which dip-switch setting

corresponds to which channel. Once the receiver channel is altered make sure to change the

transmitter channel as well. The channel on both the transmitter and receiver must be identical in

order for the system to work. To change the transmitter channel please refer to page 17.

Example: Top slot → “1”

Bottom slot → “0”

(Fig. 13)

The above dip-switch setting “1 0 0 1 0 0” corresponds to “channel 36” in the system channels

table on page 38.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 47 48

Sin comentarios

Magnetek Flex 12EX System Manual de instrucciones Pagina 29