Magnetek Flex 12RS System Manual de instrucciones descargar pdf (Pagina 16)

Flex PRO / Flex M Pre-Engineered Radio Control System Instruction Manual

April 2012

Page 16 of 42

4. DIP SWITCH SETTINGS

4.1. SYSTEM CHANNEL SETTINGS

Set the transmitter channel by adjusting the channel dip-switch located on the backside of the transmitter

encoder board (refer to Figure 7 below). Only the first five (5) positions of the dip-switch are used for

channel programming (refer to Figure 8 below). The system channels table (Section 5) illustrates which

dip-switch setting corresponds to which channel. Once the transmitter channel is altered, you must set up

the receiver to recognize the transmitters on its new channel.

Top slot → “1”

Bottom slot → “0”

Figure 7 Figure 8

The above dip-switch setting “1 0 0 1 0” corresponds to “channel 19” in the system channels table

(Section 5).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 41 42

Sin comentarios

Magnetek Flex 12RS System Manual de instrucciones Pagina 16