Magnetek Flex 12RS System Manual de instrucciones descargar pdf (Pagina 17)

Flex PRO / Flex M Pre-Engineered Radio Control System Instruction Manual

April 2012

Page 17 of 42

4.2. INACTIVITY TIME OUT TIMER

Bits 6 and 7 on the dip-switch allows the user to define a time after which, if no buttons on the transmitter

are pressed, the Flex Pro will send an OFF command to the receiver and power down. To restart, the

user must turn the On/Off/Start switch to the Off position, then back to On again to resume operation.

Figure 9

4.3. A/B/BOTH SELECT

Bit 8 on the dip-switch allows the user to set the lower left pushbutton (PB7 on the Flex 8 PRO, PB11 on

the Flex 12 PRO) into an A / B / BOTH Select button. When the A / B / BOTH Select button is enabled, it

can be used to toggle through the desired outputs as follows: A > B > BOTH > A ...

Figure 10

NOTE: When A/B Select function is Enabled, A/B LEDs will be OFF at initial startup, but will remain ON

(A, B, or BOTH) once selected. When A/B Select function is disabled, A/B LEDs will remain OFF.

Time Out

Dip-switch

Setting

5 minutes 01

10 minutes 10

15 minutes

Never shut off 00

A / B / BOTH

Dip-switch

Setting

Enabled 1

Disabled

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

Sin comentarios

Magnetek Flex 12RS System Manual de instrucciones Pagina 17