Magnetek Flex 12RS System Manual de instrucciones descargar pdf (Pagina 39)

Flex PRO / Flex M Pre-Engineered Radio Control System Instruction Manual

April 2012

Page 39 of 42

11.3. TROUBLESHOOTING TABLE

Problems Possible Reasons Suggestions

No response when

transmitter push

button is pressed

(Improper startup &

settings)

Transmitter low battery power Check the transmitter battery level.

Emergency stop button

activated prior to startup

Prior to turning on the transmitter power switch

make sure that the red emergency stop button is

elevated.

Improper startup procedure

Redo the startup procedure by holding the power

key at “START” position for up to 2.0 seconds

and then release.

Incorrect system RF channel

Make sure that the transmitter handset and the

receiver unit both have the same channel.

Incorrect Receiver Access Code

Make sure that the transmitter handset and

receiver unit both have the same Receiver

Access Code.

System out of range

Make sure that the startup procedure is initiated

within 100 meters (300 feet) from the receiver

location.

Receiver will not turn on,

+5VDC CPU/RELAY

LEDs on Power Supply

Module do not light up

Supplied voltage is out of the

acceptable range

Ensure the voltage is 120VAC nominal

Internal fuse has blown on

power supply module

Contact the factory for repair

Internal Power supply on PCB

has a problem

Contact the factory for repair

Receiver will not

respond to the

transmitter

WDG/Online LED on CPU/RF

module is blinking 2 times

(communication loss with

transmitter), and RF MSG LED

does not blink.

Make sure the receiver and transmitter unit are

both within range. Also verify that the transmitter

is still on.

WDG/Online LED on CPU/RF

module is blinking 1 time

(normal operating WDG), RF

MSG LED does not blink and

RF Signal strength LEDs are

indicating a signal strength.

Make sure the receiver and transmitter unit have

the same access code.

WDG/Online LED on CPU/RF

module is blinking 1 time

(normal operating WDG), RF

MSG LED does not blink and

RF Signal strength LEDs are

indicating an erratic signal.

Make sure the receiver and transmitter are both

set to the same channel.

WDG/Online LED on CPU/RF

module is blinking 3 times,

read/write error with relay

modules

Make sure that the modules are securely put

together; if the problem persists, contact factory

for repair.

The antenna on the receiver is

missing, damaged, or

improperly installed.

Inspect the antenna on the receiver for damage

and try to place the antenna in a location that is

visible when operating the equipment at all times.

1 2 ... 34 35 36 37 38 39 40 41 42

Comentarios a estos manuales

Sin comentarios

Magnetek Flex 12RS System Manual de instrucciones Pagina 39

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control Magnetek Flex 12RS System