Magnetek Flex 12RS System Manual de instrucciones descargar pdf (Pagina 20)

Flex PRO / Flex M Pre-Engineered Radio Control System Instruction Manual

April 2012

Page 20 of 42

5. Now press any push button on the transmitter handset to operate the equipment. When a button

is pressed, the Status LED will flash orange with a variable speed dependent on how far the button is

pressed. The further a button is pressed, the faster the LED will flash. When no buttons are pressed, the

Status LED will slowly blink green.

6. In case of an emergency, pressing down on the red emergency stop button will immediately

disconnect the receiver E-Stop and turn off the unit. To reset the emergency stop button just rotate the red

button either clockwise or counter-clockwise and then cycle power to the unit.

7. After a period of inactivity (push button not pressed) defined by the dip switch, the receiver E-Stop

will be disconnected and the unit must cycle power before turning on again.

8. Turn off the transmitter power by rotating the power key counter-clockwise to the “Off” position

(Status LED becomes a solid red for 4 seconds). This will disconnect the transmitter power and the

receiver E-Stop altogether. Turn it further counter-clockwise to release the key.

6.2. CHANGING TRANSMITTER BATTERIES

Change the transmitter batteries by unscrewing the battery cover located on the backside of the

transmitter (refer to Figures 15 and 16 below). During battery installation make sure that the ribbon is

centered between the two batteries. After changing the batteries also make sure that all screws are

tightened to avoid water, moisture, dirt, grease, or other liquid penetration.

↓

Figure 15 Figure 16

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

Sin comentarios

Magnetek Flex 12RS System Manual de instrucciones Pagina 20