Magnetek Flex 12RS System Manual de instrucciones descargar pdf (Pagina 23)

Flex 4EX System Instruction Manual

December 2012

20 of 39

71 423 56 8

INTEXT

123 56 847

4.2 RECEIVER UNIT

4.2.1 System Channel Settings

(Fig. 12)

Even though the Flex system is equipped with an automatic channel scanning mode, the

user can also set the receiver channel manually. Please refer to page 35 on how automatic

channel scanning receiver works.

Set the receiver channel by adjusting the channel dip-switch located on the receiver module

(refer to Fig. 12 above). Only the first six (6) positions are used for channel programming

(refer to Fig. 13 below). The system channels table located on page 29 illustrates which dip-

switch setting corresponds to which channel. Once the receiver channel is altered, make

sure to change transmitter channel as well. The channel on both transmitter and receiver

must be identical in order for system to work. To change the transmitter channel please refer

to page 14.

Example: Top slot → “1”

Bottom slot → “0”

(Fig. 13)

The above dip-switch setting “1 0 0 1 0 0” corresponds to “channel 36” in the system

channels table on page 29.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

Sin comentarios

Magnetek Flex 12RS System Manual de instrucciones Pagina 23