Magnetek Flex 12RS System Manual de instrucciones descargar pdf (Pagina 38)

Flex 4EX System Instruction Manual

December 2012

35 of 39

7.1.4 Automatic Channel Scanning Operating Procedure

After changing transmitter channel (refer to page 14), turn on the transmitter power and rotate

the power key switch to “Start” position and hold it there for up to 1 minute. Within this 1-minute

period the receiver will search (channel 01 - channel 62) and lock onto the newly selected

transmitter channel automatically. Please note that in order for the receiver to switch to auto-

scanning mode, prior to changing the transmitter channel, you must first deactivate the

receiver MAIN by shutting off the transmitter power or press down the emergency stop button.

Please refer to page 24 if you do not want the receiver to auto-scan all 62 channels.

Change Transmitter Channel →

7.1.5 Changing Transmitter Batteries

Change the transmitter batteries by unscrewing the battery cover located on the backside of

the transmitter (refer to Fig. 19 below). During battery installation make sure that the blue

ribbon is centered between the two batteries. After changing the batteries also make sure that

all screws are tightened to avoid water, moisture, dirt, grease, or other liquid penetration.

↓

(Fig. 19)

1 2 ... 33 34 35 36 37 38 39 40 41 42

Sin comentarios

Magnetek Flex 12RS System Manual de instrucciones Pagina 38