Magnetek Flex 12RS System Manual de instrucciones descargar pdf (Pagina 37)

Flex 4EX System Instruction Manual

December 2012

34 of 39

3rd

SPEED

e. Now press any push button on the transmitter handset to operate the crane or

equipment. During transmitter inactivity (push buttons not pressed), the transmitter will

automatically switch to standby mode, with an orange blink on the Status LED every 4-

second interval.

f. In case of an emergency, pressing the red emergency stop button will immediately

disconnect the receiver mainline (Status LED blinks red). To reset the emergency

stop button, just rotate the red button either clockwise or counter-clockwise; it will

pop up. When the green light appears, rotate the power key to the “Start” position to

resume operation (depends on JP3 setting on page 27).

g. After 5 minutes of inactivity (push button not pressed) the receiver MAIN will be

disconnected temporarily (depends on JP1 & JP2 settings on page 27). To resume

operation just rotate the power key switch to START position to reconnect the receiver

MAIN.

h. Turn off the transmitter power by rotating the power key counter-clockwise to “Off”

position; it will disconnect the transmitter power and the receiver MAIN altogether. Turn it

further counter-clockwise to release the key.

7.1.2 A/B Selector Push Button Operating Procedure

Pressing the “Select A/B” push button will toggle between output relay A, B, A+B

respectively. There are four different types of Select A/B sequences available; please refer

to page 16 for instructions on how to set Select A/B functions.

7.1.3 3

Speed Push Button Operating Procedure

When a push button is held at 2

speed, pressing the 3

Speed push button one time will

activate the 3

speed output relay (toggled). If the operator wants 2

speed again, just

press the 3

Speed push button one more time.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42

Sin comentarios

Magnetek Flex 12RS System Manual de instrucciones Pagina 37