Magnetek Enrange CAN-6 Información técnica descargar pdf (Pagina 20)

Enrange MHR Instruction Manual

August 2014

Page 19 of 57

In total, the MHR can be configured for:

 Up to 8 bi-directional Current Compensated outputs (pairs are interlocked to prevent

simultaneous motion)

 Up to 8 bi-directional PWM outputs (pairs are interlocked to prevent simultaneous motion)

 Up to 16 single directional digital ON/OFF outputs

 Up to 16 single directional digital ON/OFF inputs

NOTE: The total number of IOs on the unit is limited by its configuration, i.e. if the unit has 6 bi-

directional outputs, there will only be room for 4 digital ON/OFF outputs.

NOTE: When using PWM, the MHR supports PWM frequencies of 75 to 1000MHz for closed loop

systems and 33 to 1000MHz on open loop systems. Contact the factory if PWM frequencies

outside of these ranges are desired.

NOTE: In certain applications where the hydraulic valves utilize a negative voltage spike to

close/turn off the valve quickly (such as applications utilizing Parker Pulsar valves), Magnetek

offers the following MHR assemblies:

433MHz – 198-00149-1000

2.4GHz, 50mW – 198-00149-2000

2.4GHz, 125mW – 198-00149-3000

All operational features are the same, but the internal circuits have been optimized for use with

the Parker Pulsar valves.

2.5 MHR RECEIVER BLOCK DIAGRAM

NOTE: Connections are labeled by which side the connector is on the MHR receiver, i.e. CON1 is

on the left side, CON2 is on the right side. See Figure 6 in Section 2.4 for more detail.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 57 58

Sin comentarios

Magnetek Enrange CAN-6 Información técnica Pagina 20