Magnetek Enrange CAN-6 Información técnica descargar pdf (Pagina 8)

Enrange MHR Instruction Manual

August 2014

Page 7 of 57

 Operate the crane, hoist or lifting device unless all persons, including the operator, are and remain

clear of the supported load and any potential pinch points

 Operate a crane, hoist or lifting device when the device is not centered over the load

 Operate a crane, hoist or lifting device if the chain or wire rope is not seated properly in the

sprockets, drum or sheave

 Operate any damaged or malfunctioning crane, hoist, lifting device or other material handling

equipment

 Change any settings or controls without authorization and proper training

 Remove or obscure any warning or safety labels or tags

 Leave any load unattended while lifted

 Leave power on the radio controlled equipment when the equipment is not in operation

 Operate any material handling equipment using a damaged controller because the unit may be

unsafe

 Operate manual motions with other than manual power

 Operate radio controlled equipment when low battery indicator is on

WARNING

THE OPERATOR SHOULD NOT ATTEMPT TO REPAIR ANY RADIO CONTROLLER. IF ANY PRODUCT

PERFORMANCE OR SAFETY CONCERNS ARE OBSERVED, THE EQUIPMENT SHOULD

IMMEDIATELY BE TAKEN OUT OF SERVICE AND BE REPORTED TO THE SUPERVISOR. DAMAGED

AND INOPERABLE RADIO CONTROLLER EQUIPMENT SHOULD BE RETURNED TO MAGNETEK FOR

EVALUATION AND REPAIR. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS

INJURY OR DEATH AND DAMAGE TO EQUIPMENT.

1.4 PRE-OPERATION TEST

At the start of each work shift, or when a new operator takes control of the crane, operators should do, as a

minimum, the following steps before making lifts with any crane or hoist:

Test all warning devices.

Test all direction and speed controls.

Test the receiver emergency stop.

WARNING

BEFORE OPERATING THE RECEIVER, FAMILIARIZE YOURSELF WITH ALL SAFETY INFORMATION IN

THIS MANUAL, APPROPRIATE MANUAL SUPPLEMENTS AND ANY OTHER LOCAL, STATE, OR

FEDERAL RULES OR REGULATIONS ALREADY IN EXISTENCE. FAILURE TO FOLLOW THIS

WARNING COULD RESULT IN SERIOUS INJURY OR DEATH AND DAMAGE TO EQUIPMENT.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 57 58

Sin comentarios

Magnetek Enrange CAN-6 Información técnica Pagina 8