Magnetek Enrange CAN-6 Información técnica descargar pdf (Pagina 42)

Enrange MHR Instruction Manual

August 2014

Page 41 of 57

WARNING

THE ACCESS CODES IN THE RECEIVER ARE UNIQUE AND FACTORY PRESET. DO NOT CHANGE

THESE ACCESS CODES UNLESS YOU ARE REPLACING AN EXISTING RECEIVER AND ITS ACCESS

CODE. CHANGING THIS CODE COULD MAKE IT COMMON WITH ANOTHER RECEIVER ACCESS

CODE, WHICH COULD MOVE OTHER EQUIPMENT. NO TWO SYSTEMS IN ANY LOCATION SHOULD

EVER HAVE THE SAME ACCESS CODES INDEPENDENT OF THE FREQUENCY. FAILURE TO

FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH, AND DAMAGE TO

EQUIPMENT.

5.3 CONNECTING THE MHR TO A COMPUTER

The MHR receiver contains circuits that permit communication with a computer system via USB.

If the MHR receiver was ordered with the 195-50481 MHR Pre-Wired Cable kit, the 195-50539

MHR USB cable can be added by simply plugging in the connector. This option provides a USB-

mini B plug for connection to a computer system.

If not using the MHR Pre-wired Cable Kit, the MHR can be wired for USB connection using the

pin outs in the figure below.

When plugging in an MHR receiver to a computer system, it is strongly recommended that a USB

isolation hub, like Magnetek part 195-50645, is used between the MHR and the computer system.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 57 58

Sin comentarios

Magnetek Enrange CAN-6 Información técnica Pagina 42