Magnetek Enrange CAN-6 Información técnica descargar pdf (Pagina 24)

Enrange MHR Instruction Manual

August 2014

Page 23 of 57

3.0 CONFIGURING THE MHR

The Setup Mode can be used to edit configuration settings so that the MHR can be used in many

different scenarios.

NOTE: No parameter changes will take effect until the user has selected ‘Save and Exit’ from the

Setup Mode.

3.1 ENTERING SETUP MODE

To enter the setup mode, hold the UP and BACK buttons at the same time. If the password

feature is enabled on the MHR, you will be prompted for a password prior to entering setup mode.

Example for entering setup mode on the MHR is as follows:

Press and hold

and together at the same time for 5 seconds. When the buttons are

properly pressed, the Enter Password screen or Setup Mode menu screen will be displayed.

Figure 10: Enter Password screen

Enter Password Screen: Enter the password one digit at a time. The password can range from

0000 to 9999.

Use the

and arrows to change the values and and to cycle through each

digit.

After the last digit is entered on the far right side of the password enter screen, press

enter setup menu.

NOTE: The factory default password is 3579.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 57 58

Sin comentarios

Magnetek Enrange CAN-6 Información técnica Pagina 24