Magnetek Enrange CAN-6 Información técnica descargar pdf (Pagina 40)

Enrange MHR Instruction Manual

August 2014

Page 39 of 57

4.4 LED STATUS INDICATION

The MHR has two LEDs for indicating the MHR status at a glance during normal operation. The

left LED indicates the MHR’s status while the right LED indicates power/communication.

4.4.1 STATUS/ERR LED (left LED on MHR faceplate)

Solid Green = Okay, no errors present

Solid Red = Error

Check the main screen for the error code and refer to Section 7.0 for troubleshooting and alarm

code tables.

4.4.2 PWR/COMM LED (right LED on MHR faceplate)

Solid Blue = MHR is powered on

Solid Green = Active communication with transmitter

NOTE: The PWR/COMM LED illuminating solid green only occurs during the sending and

receiving of data from the transmitter. When no data is being sent or received the LED will

illuminate a solid blue.

NOTE: PWR/COMM only illuminates green when receiver is online with the transmitter. The

PWR/COMM will not illuminate green after the transmitter goes offline from the receiver. This can

occur when the transmitter powers down from inactivity or goes out of range. The start switch on

the transmitter must be toggled to bring the transmitter back online with the receiver.

STATUS/ERR

Indication LED

PWR/COMM

Indication LED

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 57 58

Sin comentarios

Magnetek Enrange CAN-6 Información técnica Pagina 40